The Drake Cold Plunge

Fully Insulated for Maximum Efficiency with 4" thick tub walls and 2" insulated lid retain temperature and reduce energy usage.

How to Maintain the Water

Our tubs are designed for easy use with minimal upkeep. The ozone system and large filter keep your water fresh, but regular changes are key.

• Replace the filter and change the water every 2–3 months for residential use.
• Change sooner if the water becomes cloudy or jet flow slows.
• A little care goes a long way to keep your cold tub in the best shape.

💡 Tip: We recommend changing the water and filter at the same time while you’re already closing the valves and turning off the tub.

How to Change the Filter (How-to Video)

1. Locate the Filter: Open the back vent to access.

2. Turn Off Electrical: Switch off the power strip inside tub compartment.

3. Turn Off Water Flow: Close both blue valves so they’re perpendicular to the plumbing.

4. Remove the Old Filter: Press the red pressure relief button on top of the filter head. Twist the blue housing counterclockwise to remove.

5. Insert the New Filter: Unwrap the new filter, place it in the housing, and center it.

6. Secure the Filter: Check the gasket is seated, then hand-tighten the housing.

7. Resume Operation: Open both blue valves so they’re parallel to the plumbing. Turn the power strip back on inside the tub compartment.

8. Inspect: Confirm there are no leaks.

Drain & Refill

1. Attach the Hose: Connect a garden hose securely to the brass hose spigot on the tub. 

2. Find a Drain Area: Place the hose where water can flow out (driveway, drain, etc.)

3. Open the Hose Valve: Turn the blue valve above the brass hose spigot to start draining.

4. Power Off: Before the tub is completely empty, switch off the power inside the compartment. Important: Never run the pump dry—always turn it off once the water level gets low to prevent pump damage.

5. Refill the Tub: Close the blue valve above the brass hose spigot to begin refilling. 

💡 Tip: If you're in a rush and want to remove water quickly, grab a large bucket and manually scoop the water out.

Commercial Use: 

For high-traffic settings, we recommend changing both the filter and water more frequently. Please review the Commercial Use Guide for best practices, including detailed water care tips and chemical use recommendations.

How to Clean the Tub Body and EVA Foam Surfaces

To Clean the EVA Foam Surfaces

• Dish Soap Solution: Mix just a few drops of dish soap with warm water.
• Wipe: Use a soft cloth or sponge to gently clean the foam.
• Rinse & Dry: Rinse with clean water and dry thoroughly with a towel.

To Clean the Tub Body

• Wipe down the roto-molded plastic body with water and a towel.
• For a deeper clean, we recommend using Simple Green spray.

Non-slip, comfortable, durable surface on both step stool, cover, and plunge top complete with SISU branding.

Includes a 1/2 HP Chiller that cools down to 39°F and only activates, as needed, to maintain temperature

The fully enclosed design keeps all components protected and out of sight, while the Yeti-inspired exterior is tough, sleek, and made to maintain cold temperatures in any environment. No clutter. No exposed parts. Just clean lines, durable, and reliable results.

Complete your sauna experience with the power of contrast therapy. Shop our saunas here.